Custom caution signs, engraved in yellow acrylic

For hazards that will kill or seriously injure if not avoided. Red plate, white letters, with the word engraved as a reversed band.

For hazards that could kill or seriously injure: stored energy, automatic starts, more than one source. Orange plate, black letters.

For hazards that could cause minor or moderate injury: hot surfaces, pinch points, noise, traffic. Yellow plate, black letters.

Information and rules with no hazard to people: access, clearances, housekeeping. Blue plate, white letters.

Green SAFETY FIRST signs for the everyday rules of a safe shop: report injuries and hazards, lift with your legs, hold the handrail, clean up as you go. Plus green plates that mark naloxone kits, stretchers, safety showers and emergency phones.

Tell people what to put on before they walk in: hard hats, eye, face and hearing protection, respirators, gloves, footwear, hi-vis, arc-rated and welding gear, plus PPE station and visitor tags. Blue plate, white letters, the mandatory-action colour.

Guarding, pinch and crush, conveyor, robot cell, press, grinder and laser warnings for plant floors and shops, plus small tags that mount right on the guard or control station. Engraved plates hold up to oil, coolant and wash-down.

Numbered energy isolation points for your lockout procedures: electrical, pneumatic, hydraulic, steam, gas and stored energy, plus the stations and reminders around them.

Danger signs for hatches and manways, the entry rules that go beside them (permit, attendant, air testing, ventilation, rescue), and numbered tags that tie each tank, vault, pit or manhole to its hazard assessment.

Numbered anchor and lifeline tags with their ratings, roof edge, skylight and hatch warnings, harness checks and the ladder rules people forget, for roofs, mezzanines, platforms and job sites.

Rated capacity plates for bridge cranes, hoists, jibs, monorails and lifting devices, big enough to read from the floor, plus the load limits for floors, mezzanines, racking, shelves, elevators and dock levellers.

Gate, hoarding and site office signs, excavation, open hole and overhead work warnings, scaffold status tags, and the hot work, temporary power and dust rules a constructor posts on a job site.

Forklift and pedestrian traffic, loading docks, racking loads and aisle rules for warehouses, plants and distribution centres. Engraved plates that stand up to a busy floor.

Storage room, cabinet and cylinder signs for flammables, oxidizers, corrosives, compressed and toxic gases, fuel and used-oil tank tags, plus SDS and spill stations. Engraved plates stand up to splashes and wipe-downs that peel printed stickers.

Do-not-disturb tags for asbestos pipe insulation, ceilings and flooring, the signs a Type 3 removal needs at the enclosure and the decontamination facility, and work-area signs for lead, silica, mould and isocyanates. Engraved plates outlast the paper labels that fall off long before the asbestos is gone.

Containment-level biohazard doors, radiation signs for nuclear substance labs and gauge storage, laser signs by class, and the x-ray, MRI, cryogen, fume hood and lab PPE signs research and hospital labs post. Engraved plates hold up to disinfectant wipe-downs.

Extinguisher, hose cabinet, sprinkler, standpipe and fire department connection signs, plus the riser, valve, drain and hydrant tags inspectors check. Red plate, white letters, so responders find them fast.

Fire alarm, generator, transfer switch, emergency power and shut-off labels, plus the exit, evacuation, AED, eyewash and muster point signs people need to find fast.

Service, disconnect, transformer and capacitor warnings, plus the conductor and fuse tags an inspector looks for. Danger and warning plates for hazards, black and white for equipment ID.

Warnings for switchboards, panelboards, MCCs and disconnects that may be examined or worked on while energized. Send your study data for full incident-energy labels.

Panel names, voltage and phase, what feeds it and what it feeds. Black with white letters is the shop standard; any stocked pair works.

MCC buckets, starters, VFDs, contactors, pumps, fans, control panels and the push-button and selector legends on them.